◄►

Floor Gully

Feedback on this page as e-mail
Function Operations  

The dialog configures the properties of an object for waste water pipes . The function covers the following subgroups:

  • Gully
  • Drainage channel
  • Manhole
  • Separator

Settings, functions and parameters

Properties

The field indicate the main properties of the selected product. The relevant values are taken from the product database and cannot be changed. You can insert a value in this field, this value is irrelevant for the specific object.

With the setting (0/1) you define the medium to be derived.

Setting Effect
0 Wastewater
1 Rainwater

Placement

Selection of a reference line in the building to define the mounting height. The selected product determines the reference to the object.

For this function, there are products for surface mounting (on the ceiling) and flush mounting (in the ceiling).

Setting Effect
Roof Type Mounting Flush Type Mounting
Ceiling (FCL)

The value at Distance refers to the height of the ceiling (at room height).
Suspended Ceiling (SCL)

The value at Distance refers to the height of the suspended ceiling.
Finished Floor (FFL)

The value at Distance refers to the upper edge of the finished floor level.
Slab (SSL)

The value at Distance refers to the upper edge of the unfinished floor level.
Free

The mounting height is independent of the building model. The value in Distance refers to the height Z=0 in the absolute coordinate system.
User 1 - …User 4 -

The entries User 1 - to User 4 - contain variable standard heights. You can select and modify a standard height (e.g. User 3 - 0.850). To do so, Product is activated for input. The entered value is stored for this entry as new standard height and can also be selected for other objects. This change has no effect on the mounting height of already inserted objects, these are automatically assigned the setting Free.

Depending on the selected product for flush or surface mounting: distance between the selected reference and the upper or lower edge of the object.

In the case of settings Free and User 1 - … User 4 - you can enter the mounting height as a number with the desired length unit.

Change-over switch for the operating direction of the value in Distance.

Installation above the selected reference.
Installation below the selected reference.

Setting for the behaviour of the object in the event that the height of the selected reference in the building model changes. ClosedExample

Setting Effect

DDScad calculates a new value for Distance. The object ignores the change of the building model.

DDScad checks changes in the height ratio between the object and the selected reference using the function Check and Verify Models.ClosedWorkflow

Type

DDScad differentiates the parts list based on the number (= product number). It is set when the item is selected, but can be entered manually if known.

Setting Effect
The object is included in the parts list.
The object is not included in the parts list.

Opens the product database and allows the selection of a product.