Basin/Sink/Bidet

The default setting is Free. The insertion point is defined for most objects in this group so that at mounting height=0 it is placed at its typical standard height.Exceptions are the accessories, their installation should be individualized.

Setting	Effect
Ceiling (FCL)		The value at Distance refers to the height of the ceiling (at room height).
Suspended Ceiling (SCL)		The value at Distance refers to the height of the suspended ceiling.
Finished Floor (FFL)		The value at Distance refers to the upper edge of the finished floor level.
Slab (SSL)		The value at Distance refers to the upper edge of the unfinished floor level.
Free		The mounting height is independent of the building model. The value in Distance refers to the height Z=0 in the absolute coordinate system.
User 1 - …User 4 -		The entries User 1 - to User 4 - contain variable standard heights. You can select and modify a standard height (e.g. User 3 - 0.850). To do so, Product is activated for input. The entered value is stored for this entry as new standard height and can also be selected for other objects. This change has no effect on the mounting height of already inserted objects, these are automatically assigned the setting Free.

The insertion point is defined for most objects in this group so that at mounting height=0 it is placed at its typical standard height. With a value≠0 you define a deviation from the standard height.

Exceptions are the accessories; their installation should be individualized. For these objects, you define the mounting height as the distance between the top of the finished floor (FFL) and the insertion point of the object. The position of the insertion point of the object depends on the selected product.

In the case of settings Free and User 1 - … User 4 - you can enter the mounting height as a number with the desired length unit.

Change-over switch for the operating direction of the value in Distance.

	Installation above the selected reference.
	Installation below the selected reference.

Setting for the behaviour of the object in the event that the height of the selected reference in the building model changes. Example

Setting	Effect
	DDScad calculates a new value for Distance. The object ignores the change of the building model.
	DDScad checks changes in the height ratio between the object and the selected reference using the function Check and Verify Models.Workflow Close all dialogs. Select: Tools Analyze Model Check and Verify Models The dialog appears. Activate the tab: Check Model Activate: changed reference for mounting height Click OK. The test starts. DDScad will report all cases that meet the criteria.