Ventilation duct – Course
Height (vertical)

Example

Suppose you hit an obstacle and want to change the height in the route. The angle for the height change is known.

Workflow

  1. Move the duct to the position of the change in height.
  2. Define a fix point by clicking .

  3. Press

    For an upward movement [Home]
    [PgUp]
    For a downward movement [End]
    [PgDn]

    The dialog appears: Give position in flow segment

  4. Select an operation:

    1. Define the height

      Delta up: / Delta down:

      Height change as a difference to the actual height.

      Insert the value without prefix.

      Absolute Z-pos.

      Defining the new height, starting from FFL.
      For horizontal continuation, the center axis of the horizontal segment is the reference. You can use different unit of lengths.

      Angle relative to the previously defined segment.

    2. Click OK. You can draw the course.

    Click Go to Storey
    The operation is finished.