Ventilation duct – Terminate
On duct segment

Example

You can connect the ventilation duct to the segment of an existing ventilation duct. When connecting to a horizontal segment, DDScad automatically responds to a possible height difference and you can configure the connection.

Required conditions

Workflow

Move the duct to the desired connection point. The existing ventilation duct is highlighted. DDScad detects whether a height difference exists.

Without height change:

A menu lists the available options.

Read more »
1. Select the entry that displays the properties of the ventilation duct. The connection is established. The function remains active. You can set the next starting point.
With height change:

A message indicates the height difference.

Read more »
1. Pull back the ventilation duct. Clicking defines a fixed point at a location where a bend is to begin a change in height.
2. Click at the position where you want to connect it. The dialog appears: Connect ducts
3. Check the settings.
  
  Direct connection / Horizontal - Vertical / …
  
  Options for designing the connection. DDScad offers available options depending on the situation.
  
  Direct connection
  
  Direct connection from the last fix point + to the connection point (oblique height change).
  
  Horizontal - Vertical
  
  Horizontal bend to the connection point and vertical connection.
  
  Vertical - Horizontal
  
  Vertical height change in the course of the incoming ventilation duct and horizontal connection.
  
  Horizontal - Vertical - distance in
  
  Horizontal bend in the direction of the connection point, vertical height change in the set distance from the connection point and horizontal connection.
  Distance
  Setting between the point of the height change and the connection point for the options:
  - Horizontal - Vertical - distance in
  - Horizontal - Vertical - distance back
  - 90° Horizontal - (Vertical) - distance in
  15° / 30° / 45° / 60° / 90°
  
  Standard angle for the bend for the height change. The position of the bend is calculated and can be edited afterwards.
  
  Free
  
  The angle of the bend for the heigh change is calculated and is set according to the last fixed point. The first bend is located at the last fixed point, the second at the connection point. You can edit the position of the bends afterwards.
4. Click OK. The connection is established. The function remains active. You can set the next starting point.

Ventilation duct – Terminate On duct segment

Ventilation duct – Terminate
On duct segment