Ventilation duct – Terminate
At duct bend

Workflow

1. Move the duct to the bend. The bend is highlighted.

   Without height change:

   A menu lists the available options.

   

   Read more »

   2. Select the entry that displays the properties of the bend. The connection is established. The function remains active. You can set the next starting point.

   With height change:

   A message indicates the height difference.

   

   Read more »

   2. Pull back the ventilation duct. Clicking defines a fixed point at a location where a bend is to begin a change in height.
   3. Click at the position where you want to connect it. The dialog appears: Connect ducts

   4. Check the settings.

      Direct connection / Horizontal - Vertical / …

      Options for designing the connection. DDScad offers available options depending on the situation.

      Direct connection

      Direct connection from the last fix point + to the connection point (oblique height change).

      

      Horizontal - Vertical

      Horizontal bend to the connection point and vertical connection.

      

      Vertical - Horizontal

      Vertical height change in the course of the incoming ventilation duct and horizontal connection.

      

      Distance

      Setting between the point of the height change and the connection point for the options:

      • Horizontal - Vertical - distance in
      • Horizontal - Vertical - distance back
      • 90° Horizontal - (Vertical) - distance in
      15° / 30° / 45° / 60° / 90°

      Standard angle for the bend for the height change. The position of the bend is calculated and can be edited afterwards.

      Free

      The angle of the bend for the heigh change is calculated and is set according to the last fixed point. The first bend is located at the last fixed point, the second at the connection point. You can edit the position of the bends afterwards.

   5. Click OK. The connection is established. The function remains active. You can set the next starting point.